Ohlins SUPERBIKE FG 570 - Manual (Page 22)

Technical information
Fork length: 730 mm.
Stroke: 130 mm.
Free spring length: 260 mm.
Rebound adjustment:
Base setting 9-12 “clicks”.
Maximum open valve 20 “clicks”.
Compression adjustment:
Base setting 6-16 “clicks”.
Maximum open valve 20 “clicks”.
Compression adjustment (Base valve):
Base setting 6-16 “clicks”.
Maximum open valve 20 “clicks”.
Spring pre-load adjustment:
0-18 mm (0-18 turns).
Spring rate:
4744-95 9.5 N/mm (marking -95).
Optional springs supplied:
4744-10 10.0 N/mm (marking -10)
4744-90 9.0 N/mm (marking -90)
Optional springs:
4744-85 8.5 N/mm (marking -85)
4744-80 8.0 N/mm (marking -80)
Oil Capacity:
Please see specification card.
Use Öhlins high performance front fork
fluid No. 5 (1311-01) only.
Tighten torque:
Lower triple clamp bolt 12-15 Nm.
Upper triple clamp bolt 18-22 Nm
Grease:
Öhlins front fork grease 146-01
(red grease).
Service interval:
Every 10 hours
22
Tighten torque, Loctite and Grease:
Fork leg, 140 Nm Loctite 542
Screw
, 3 Nm
Both fill-up points
Cylinder tube, 80 Nm Loctite 648
Nut, 7 Nm Loctite 222
Screw
, 3 Nm
Seal head, 20 Nm
Piston rod/piston shaft, 15 Nm Loctite 270
Red grease
Inside of reservoir tube White grease, thin film
Reservoir tube, 45 Nm
Nut, 7 Nm Loctite 222
Base valve, 45 Nm
Attach piston holder to rod before assemble piston details!
X-ring White grease
Rod extensioner/bolt spring adjuster
, 20 Nm
Piston shaft/rod extensioner
, 15 Nm
Loctite 270
Adjustment housing, By hand only
O-ring, No grease
Upper bushing Loctite 601
Red grease on all other o-rings!
Lower bushing No loctite