Onkyo TX-DS777 - Manual (Page 27)

27
** Input Selector **
Input = DVD
OPTICAL 1
Digital Input Setup
Video Assign Setup
IntelliVolume Setup
Listening Dolby
Mode= Pro Logic
THX Cinema
• Selecting an input source using the on-screen
display
Instead of using the input selector buttons, you can use on-screen
display to select the desired input source.
1. Press the OSD MENU button.
2. Select “Input Selector” and then press the right edge of the
ENTER/Cursor button.
3. Press the upper or lower edge of the ENTER/Cursor button
to select “Input” and then press the right or left edge of the
button to select an input source.
• When you select DVD, CD, VIDEO 1- 3, or TAPE, set the
digital input parameters on the Digital Input Setup screen.
(See page 29.)
• When you have selected TUNER, the currently selected pre-
set number is displayed on the next line.
• See page 33 for information on MULTICH INPUT.
4. Press the center of the ENTER/Cursor button, or press the
EXIT button, to exit the setup mode.
3
Selecting an input source
If no sound is heard from the speakers, check the
following items:
• When you have selected DVD, CD, VIDEO 1- 3, or TAPE,
check the “digital input setup” is correct. (See page 23.)
• Make sure that the input signal format setting is correct. (See
page 28,29.)
• The Muting function may be activated. Cancel the Muting func-
tion. (See “Muting the sound” on page 31.)
• Make sure that SPEAKERS A is selected. (See “Selecting the
speaker system” on page 30.)
Warning:
• Do not play CD-ROM discs that contain computer data as they
may damage the speakers when the sound is amplified by the
receiver.
2
. SP A
1 SLEEP
2 MODE AUDIO
4
. VOLUME
∆
/
∇
1
. INPUT SELECTOR
3 DIMMER
1 This button allows you to set the sleep timer.
(See page 31.)
2 Press this button to set the mode in which you can operate the
TX-DS777/676.
3 Use this button to change the brightness of the display (normal
or dim).
For the European model, this button is not provided on the front
panel. Change the display brightness using the remote control-
ler.
4 You can connect stereo headphones to the PHONES jack using
a standard stereo plug.
(When you connect headphones, the unit will enter STEREO
mode automatically and no sound will be heard from the speakers.)