Ohlins FG 470 - Manual (Page 11)

22 23
Upper bushing
Lower bushing
Heat air gun
22.
Remove the outer tube, clean the seal and
check the condition. If the seal is in good
condition apply some red grease (146-01)
to it. A damaged seal must be replaced!
23.
First remove the circlip, then the seal and
finally the washer.
24.
Heat the tube where the bushings are posi-
tioned. Use a heat air gun.
25.
Put the outer tube standing up on a soft
suface, seal side facing down. Remove the
bushings by pushing them out. Use attach-
ment bar (1757-01) and dismantling sleeve
(1759-07) from the top nut side.
26.
Tap gently on the attachment bar with a
heavy hammer, until the bushings are free
and can be released from the seal side of
the outer tube.
27.
Check the innertube for damages, replace
if necessary. Use a heat gun to warm up
the fork bottom and tool 786-05 to un-
screw the inner tube of the fork leg.
28.
Check the reservoir tube for damages,
replace if necessary. Use tool 786-07 to
unscrew the reservoir tube.
24 25
Attachment bar
(1757-01)
Dismantling sleeve
(1759-07)
Rubber mat
26 27
Tool 786-07
180 0
1st, Circlip
2nd, Seal
3rd, Washer
28
Tool 786-05
11