O'Neil microFlash Series - Manual (Page 55)

User Manual and Technical Guide The O'Neil microFlash Series of Printers
•
45
Batteries
The microFlash2 will run using an internal Ni-Cad battery pack. The
microFlash3 printer will run using an internal Nickel Metal Hydride
battery (DR30). The microFlash 2t//2tCR/2i/2iCR printer will run using
an internal Nickel Metal Hydride (DR10). The microFlash 4/4tcr printer
uses 1 or 2 Lithium-ion battery packs. The microFlash series of printers
can be charged on the road, with a cigarette lighter adapter or at home or
the office with an AC adapter.
microFlash2 Battery Power
To determine the current charge on the battery pack, print out a self test
by pressing and holding the red self-test button for four seconds. If the
battery is good, you will see the abbreviation for the word “GOOD” next
to the Battery voltage print out.
The microFlash2 printer has a built in low battery detector. When the
printer's battery voltage is low, the printer will beep three times,
indicating a Low Battery Warning. This will only happen however, if the
printer is awake.
The microFlash2 is charged in approximately one hour.
WARNING: Use only the batteries specified for the microFlash by
O’Neil Product Development. Using non-approved batteries will void
your warranty.
5