Onkyo CR-445 - Manual (Page 42)

Troubleshooting—Continued
42
• Some functions may not be available depending on the iPod model, software version or contents being
played. Update the iPod software to the latest version.
• The iPod item (highlighted) can be moved by [ ] / [ ] buttons during the (iPod menu mode
indicator) is lit. If the tracks are skipped by pressing [ ] / [ ] buttons, press the remote controller’s
[MENU / CLEAR] button and confirm the indicator on the display. Then press [ ] / [ ] buttons.
External Components
No sound is heard from a connected component.
• Make sure the correct input source is selected (see page 18).
• Make sure the analog audio cable is connected correctly (see page 16).
• Make sure that all audio connecting plugs are pushed in all the way (see page 16).
No sound is heard from your turntable.
• Make sure the turntable has a built-in phono equalizer.
• If the turntable doesn’t have a phono equalizer built-in, you must provide one.
Remote Controller
The remote controller doesn’t work properly.
• Make sure the batteries have been installed with the correct polarity (+ / –) (see page 6).
• Replace both batteries with new ones. (Do not mix different types of batteries or new and old batteries.)
• The remote controller is too far away from the CD receiver, or there’s an obstacle between them.
• The CD receiver’s remote control sensor is being subjected to bright light (inverter-type fluorescent light or
sunlight).
• The CD receiver is located behind the colored glass doors of an audio rack or cabinet.
Timers
Timer playback doesn’t work.
• Make sure the clock has been set correctly (see page 36).
• Timed operation will fail if the CD receiver is on at the specified On time, so make sure it’s set to Standby.
• The timer may overlap with another timer. If you program several timers, make sure they don’t overlap.
• If you press the [SLEEP] or [TIMER] button while a timed operation is in progress, the timer will be
cancelled.
Clock
The time is not displayed in Standby mode.
• The clock is not displayed in Standby mode. Press CLOCK CALL, the clock display appears for eight
seconds.
• If there is a power failure, the clock will stop and “Adjust” will appear when the clock is displayed with the
CLOCK CALL button. Set the clock in this case.
Others
“RESET” appears after the power cord is connected.
• Because the power cord was disconnected for a long time, the memory contents have been reset and all
settings returned to the factory default settings. Perform the required settings again.
The power turns on when the power cord is connected to a power outlet.
• If the power cord is disconnected while the power is ON, the power will turn ON the next time the power
cord is connected. If there is a power failure while the power is ON, disconnect the power cord.
Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by the
unit’s malfunction. Before you record important data, make sure that the material will be recorded correctly.
The CD receiver contains a microcomputer for control functions. In very rare situations, severe interference,
noise from an external source, or static electricity may cause it to lockup. In the unlikely event that this should
happen, unplug the power cord, wait at least 5 seconds, and then plug it again.
If it’s not cleared, please refer to “How to reset to factory default?” on page 40.