Onkyo ED-901 - Manual (Page 2)

2
Thank you
for your purchase of the
ONKYO ED-901 Dolby Surround AC-3 Decorder.
Please read this manual thoroughly before making connections
and plugging in the AC power cord.
Following the instructions in this manual will enable you to
obtain optimum performance and maximum listening enjoy-
ment from your new ED-901.
Please retain this manual for future reference.
Features
AC-3 Decorder with Lucas Film Cinema Re-
EQ
LFE (Low Frequency Effects) Level Control
(0dB or -10dB)
Midnight Theater for late night listening at
low volume
2-Input (VDP/DVD)
ATTENTION FOR BRITISH MODEL
• Replacement and mounting of an AC plug on the power
supply cord of this unit should be performed only by qualified
service personnel.
• IMPORTANT: The wires in the mains lead are coloured in
accordance with the following code:
Blue:
Neutral
Brown: Live
As the colours of the wires in the mains lead of this apparatus
may not correspond with the coloured markings identifying the
terminals in your plug, proceed as follows:
The wire which is coloured blue must be connected to the
terminal which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the
terminal which is marked with the letter L or coloured red.
FOR CANADIAN MODEL:
(POUR LE MODELE CANADIEN)
• For models having a power cord with a polarized plug
CAUTION :TO PREVENT ELECTRIC SHOCK, MATCH
WIDE BLADE OF PLUG TOWIDE SLOT, FULLY INSERT.
• THIS DIGITAL APPARATUS DOES NOT EXCEED THE
CLASS B LIMITS FOR RADIO NOISE EMISSION FROM
DIGITAL APPARATUS SET OUT IN THE
RADIOINTERFERENCE REGULATIONS OF THE
CANADIAN DEPARTMENT OF COMMUNICATIONS.
• Sur les modèles dont la fiche est polarisée.
ATTENTION: POUR ÉVITER LES CHOCS ÉLECTRI-
QUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA
FICHE DANS LA BORNE CORRESPONDANTE DE LA
PRISE ET POUSSER JUSQ’AU FOND.
• L'INTERFERENCE, RADIO ELECTRIQUE GENEREE
PAR CET APPAREIL NUMERIQUE DE TYPE B NE
DEPASSE PAS LES LIMITES ENONCEES DANS LE
REGLEMENT SUL LES PERTURBATIONS RADIO
ELECTRIQUES, SECTION APPAREIL NUMERIQUE, DU
MINISTERE DES COMMUNICATIONS.
FOR U.S.A. MODEL:
FCC INFORMATION FOR USER
CAUTION:
Changes or modifications not expressly approved by the
manufacturer for compliance could void the user’s authority
to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guaran-
tee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
WARNING
“TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN
OR MOISTURE.”
CAUTION
“TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USER-SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.”
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
• The lightning flash with arrowhead symbol, within
an equilateral triangle, is intended to alert the user to
the presence of uninsulated “dangerous voltage”
within the product’s enclosure that may be of
sufficient magnitude to constitute a risk of electric
shock to persons.
• The exclamation point within an equilateral triangle
is intended to alert the user to the presence of
important operating and maintenance (servicing)
instructions in the literature accompanying the
appliance.
Declaration of Conformity
We, ONKYO EUROPE
ELECTRONICS GMBH
INDUSTRIESTRASSE 18/20
82110 GERMERING,
GERMANY
declare in own responsibility, that the ONKYO product described
in this instruction manual is in compliance with the corresponding
technical standards such as EN55013, EN55020, EN60555-2, -3
and EN60065
GERMERING,GERMANY
ONKYO EUROPE ELECTRONICS GMBH
H. YAMAZOE