Onkyo PA-MC5500 - Manual (Page 4)

4
Precautions
—Continued
For British models
Replacement and mounting of an AC plug on the power
supply cord of this unit should be performed only by
qualified service personnel.
IMPORTANT
The wires in the mains lead are coloured in accordance
with the following code:
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead of this appa-
ratus may not correspond with the coloured markings
identifying the terminals in your plug, proceed as fol-
lows:
The wire which is coloured blue must be connected to
the terminal which is marked with the letter N or
coloured black.
The wire which is coloured brown must be connected to
the terminal which is marked with the letter L or
coloured red.
IMPORTANT
The plug is fitted with an appropriate fuse. If the fuse
needs to be replaced, the replacement fuse must
approved by ASTA or BSI to BS1362 and have the same
ampere rating as that indicated on the plug. Check for the
ASTA mark or the BSI mark on the body of the fuse.
If the power cord’s plug is not suitable for your socket
outlets, cut it off and fit a suitable plug. Fit a suitable fuse
in the plug.
For European Models
Features
■ 150 Watts per channel, minimum RMS into
8 ohms, 2 channels driven, from 20 to
20,000 Hz with no more than 0.05 % total
harmonic distortion
■ THX™ Ultra2™ certified *1
■ WRAT–Wide Range Amplifier Technology
(5 Hz-100 kHz bandwidth)
■ Push-Pull amplification design with three-
stage inverted Darlington circuitry
■ Massive toroidal transformer
■ Customized 22,000 µF large capacitors for
effective power supply
■ Audio-tuned reference capacitors for each
channel
■ Low-impedance, copper bus plates for
perfect ground potential
■ Gold-plated, XLR and machined, solid brass
RCA input terminals
■ Custom-designed large power transistors to
drive high currents
■ High-current, low-impedance circuit board
by using thick copper foil (70 µ)
■ Gold-plated, color-coded, transparent
speaker posts
■ Auto power-down function
■ Multi-zone capability (up to Zone 3) *2
■ Bi-amping capability *2
■ 12V trigger in
■ Aluminum front panel
■ Detachable power cord
*1
THX and Ultra2 are trademarks of THX Ltd. THX may be
registered in some jurisdictions. All rights reserved.
*2 Depends on AV controller.
Declaration of Conformity
We, ONKYO EUROPE
ELECTRONICS GmbH
LIEGNITZERSTRASSE 6,
82194 GROEBENZELL,
GERMANY
GROEBENZELL, GERMANY
ONKYO EUROPE ELECTRONICS GmbH
K. MIYAGI
declare in own responsibility, that the ONKYO product
described in this instruction manual is in compliance with the
corresponding technical standards such as EN60065,
EN55013, EN55020 and EN61000-3-2, -3-3.