Sylvania RSEC720E - Manual (Page 27)

- 27 - EN
1C29
SPECIAL PLAYBACK
This function enables you to improve the picture
quality when playing back worn cassettes such as
rented tapes.
1
Select “USER’S SET UP”
Press the SETUP button on the
remote control.
Press the Arrow button K or L to
point to “USER’S SET UP”.
Then press the ENTER button.
2
Set “RENTAL” to [ON]
Press the Arrow button K or L to
point to “RENTAL”.
Press the ENTER button until [ON]
appears.
3
Exit the Rental setting
Press the SETUP button on the remote control to
return to the TV mode.
4
Start playback
Press the PLAY button to start playback. “RENTAL
PLAY B” appears.
• Once you select the Rental mode, it stays in effect
even after you turn off the unit.
TO CANCEL THE RENTAL MODE
Repeat steps [1] to [2], select [OFF] using the
ENTER button on the remote control. Press the
SETUP button on the remote control to return to TV
mode.
If there is a power failure of any kind, the
tv/vcr/dvd will retain its memory for this feature.
TV/VCR
Make sure ...
• The unit must be turned on.
•
Insert a prerecorded tape.
RENTAL PLAYBACK The unit has the auto repeat function that allows you
to repeat a tape indefinitely without touching the
PLAY button.
ALL REPEAT: Repeat playback from the beginning
to the end of the tape.
BLANK REPEAT : Repeat playback from the begin-
ning to a blank part, which is blank for more than
10 seconds.
1
Select “USER’S SET UP”
Press the SETUP button on the
remote control.
Press the Arrow button K or L to
point to “USER’S SET UP”.
Then press the ENTER button.
2
Select “ALL” or “BLANK”
Press the Arrow button K or L to
point to “REPEAT PLAY”.
Press the ENTER button repeatedly
until your desired selection [ALL]
or [BLANK] appears.
3
Exit the Repeat Play setting
Press the SETUP button on the remote control to
return to the TV mode.
4
Start playback
Press the PLAY button to start the Repeat Play.
“REPEAT PLAY B” appears.
• Once you selectu8 26.025 Tw 9 2dysepen repeatedlyefturn tfOnceev.29after025 T •