Opticon LPR5627 - Manual (Page 22)

Manual No. 25-ULPNR101-03; Feb, 2003 LPN5627 / LPR5627 Laser Fixed Mount
Scanner
Page 18
change only a few parameters at one time. We recommend that you keep a record of the changes you
have made to the scanner.
What if you make a mistake?
Don’t worry. If you are programming the scanner but are unsure of which parameters have been
changed, scan the Reset All Defaults bar code. This bar code returns the scanner to the default
settings that were installed in the factory at the time the product was manufactured. Scanning this bar
code erases any change you have made, including any changes that were made during previous
programming.
Reset All Defaults U1 Command (U1)
This command will return all setting to the factory default setting that were installed in the factory
We recommend that after you have reset all defaults you also set the commands for No Handshaking
(P0), All Symbologies (A0), and Do Not Transmit Start/Stop Characters (D0) for Code 39.
Reset All Defaults
Computer
Command
Function / Description Bar Code Command
Z7 START/END Programming Mode
-[8-
U1 Reset All Defaults
-V2-
A0 Decodes all Symbologies
-B1-
P0 No Handshaking
-Q1-
D0 For Code 39: do not transmit
start/stop characters *….*
-E1-
Z2 Save settings in memory
-[3-
Z7 START/END Programming Mode
-[8-
Appendix C contains all the Bar Code Programming menus and commands