Olympia CM1830 - Manual (Page 10)

Quick Reference CM 1830 Cash Register 5/621/3300 (13)
Olympia 09.2001 Page 10 All rights reserved.
Error messages: operation
Error messages appear in the display and an acoustic signal is issued as a result of incorrect operation.
6 Error message is cleared
Error
message Cause
E00 Incorrect key pressed
E01 Incorrect key operation sequence
E02 A number/digit sequence (with decimal point) must be
entered or the entry is too long
E03 Result exceeds permitted number of digits or is zero
E04 Result exceeds permitted number of digits or is zero
E10 Incorrect key pressed
E20 Card payments related to negative values are not
accepted
E24 Electronic cash-card used for payment not recognized
E30 This operation must be performed within a registration
E31 This operation must be performed outside a registration
E32 ( БЗЕЕ ) PLU number in the registration outside the range
E33 PLU in the registration could not be found
E40 The operation requires the input of a number
E41 The operation does not require the input of a number
E42 The operation accepts the input of a zero
E43 The number entered exceeds the range
E44 The digits entered exceeds the range for PLU input
E45 Result cannot be rounded
E46 Result cannot be rounded
E47 The maximum permissible amount for checks has been
exceeded
E48 The percentage value is outside the range
E50 The operation does not accept the entry of a decimal
point
E51 The decimal point has already been entered
E52 The number of decimal places for percentage input
exceeds 2
Error
message Cause
E60 The item barcode is valid but not found in the PLU
database.
E61 This item has been withdrawn from sales
E62 This department has been withdrawn from sales
E63 Discount is possible for this PLU registration
E64 The PLU index is outside the range
E65 The number of digits permitted for price entry for
departments has been exceeded
E70 It is not necessary to enter the clerk code
E71 The clerk code entered exceeds four digits
E72 The clerk code is incorrect
E80 The input must be positive or zero
E81 The item barcode was not found / recognized
E82 The result exceeds the range
E83 The sum exceeds the range
E84 The counter for the validation printout exceeds the
permissible value
¿КЛВГА¸ГБЗЕЕ
The total amount in the cash register drawer exceeds the
permissible value
E86 Operating mode R/T has been changed
E87 Price input zero has been blocked
E88 Compulsory to enter the change
E89 Pay out amount is greater than the amount in the cash
drawer
E90 º¸ЖД Printer fault (jam)
E91 º¸ЖБ Printer memory is full
E92 A fixed key cannot be reprogrammed
Å»½ Clerk code must be entered, up to four digits
Е¿В½ Language change when entering the language code
Caution!
All settings will be lost!
П¹Й
Change keyboard assignment
Only enter the following when you are familiar with the programming functions!
Caution:
Set the key to position P
After pressing the following key combination, the daily sales, grand total and all programmed settings
(departments, PLUs, Flags etc.) are deleted.
k ¿Е¹К¸ appears in the display
y
All programmed settings and sales figures are deleted
After pressing the following key combination, all the programmed settings (departments, PLUs, etc.) are
deleted and reset to their "default state".
U А¹БКЗЕ¼Г
appears in the display
y
The department and PLU prices are reset
After pressing the following key combination, the grand total is reset. It is only executed when the
Full Z-report and Monthly Report were printed out beforehand.
s ¿Е¹К¸
appears in the display
y
The grand total is deleted