Oreck U2200RD - Manual (Page 5)

BAG REMOVAL:
1. Pull bag cardboard collar to
release bag dock door from
connector.
2. Gently pull bag cardboard
collar upward out of the bag
dock.
5
T o R eplace F ilter
D ust B ag
All paper dust bags are not the same. Your ORECK
disposable dust bags have been designed to be used with the
ORECK cleaner. Using bags other than genuine ORECK TYPE
CC disposable bags will affect the cleaning ability of your
cleaner and could cause damage to it.
The Belt
The belt on your vacuum cleaner controls the speed of the
revolving brush and is very important for the effective
operation of the cleaner. If the belt becomes stretched or cut,
it will cause the revolving brush to stop completely or slow
down. See instructions in the manual for replacing belt.
An extra belt is stored in the baseplate of your cleaner. When
buying replacement belts, use ONLY ORECK genuine belts.
Belts other than ORECK belts will not operate the revolving
brush correctly and may create undue stress which will cause
damage to the motor and brush bearings. Using belts other
than ORECK belts will void the warranty.
Lubrication
The vacuum cleaner motor bearings are factory lubricated
and seated. Further lubrication is not required.
General Cleaner Care
At least once a month, check for
and remove excessive lint, string
or hair from revolving brush.
Wipe the outside of the cleaner
with a damp cloth. Also clean
the connector deflector assembly
area, base of cleaner and fan
housing area. If there is dust in
the outer bag, vacuum it or
shake it out.
A little preventative maintenance will keep your cleaner
looking new and will ensure continued cleaning effectiveness.
CAUTION—Wood Floors, Soft (Vinyl, Asphalt Tile,
etc.) Floor Surfaces and Polished Floor Finishes
Use floor and floor finish manufacturer’s recommended
methods of cleaning. The metal strip on the base of the
cleaner could be damaged if used on concrete or abrasive
surfaces, and, therefore, cause damage to wood floors, soft
(vinyl, asphalt tile, etc.) floor surfaces and polished floor
finishes. The roller brush may also scuff very soft finishes. Do
not operate the unit while in the upright and locked position.
Do not let the unit run while in any one stationary position for
any period of time. Keep the unit moving while in operation.
BAG INSTALLATION:
1. Slide the cardboard collar
completely onto bag dock
door.
2. Firmly push bag dock door
with both thumbs on
indication point until
it snaps.
WARNING: Unplug cord from
electrical outlet before servicing.
ENFONCEZ JUSQU ENFONCEZ JUSQU’А ’А
ENTENDRE UN BRUIT ENTENDRE UN BRUIT
PRESIONE HAST PRESIONE HASTA A
ESCUCHAR UN ESCUCHAR UN
CHASQUIDO DE SUJECI CHASQUIDO DE SUJECIÓ ÓN N
ENFONCEZ JUSQU’À
ENTENDRE UN BRUIT
PRESIONE HASTA
ESCUCHAR UN
CHASQUIDO DE SUJECIÓN