Oreck XL2400RS - Manual (Page 4)

fig. 1 Before assembling appliance, remove two screws
from the connector assembly. Remove cardboard
insert by pulling upward.
fig. 2 Slide upper handle section over matching section
of the connector assembly. Insert short screw into
top hole and long screw into the bottom hole then
tighten firmly until handle is no longer loose.
Make sure disposable paper filter dust bag is in place. DO
NOT operate the cleaner without a paper filter dust bag.
Plug the power cord into an electrical outlet and press the
On (l) - OFF(O) switch on top of base when ready to
operate.
Up-Position Lock
fig. 3
Place foot on power head and lean handle back
gently to release lock for vacuum use. Return
handle to the full upright position to engage lock.
NOTE: Do not operate the unit while in the upright and
locked position. Do not let the unit run while in any one
stationary position for any period of time. Keep the unit
moving while in operation.
For Easy Power Cord Storage
fig. 4
Wrap power cord around cord hook on handle
and cord hook on connector. Secure to “U”
shaped part on plug.
WARNING: Unplug cord from electrical outlet
before servicing.
fig. 5 Unzip outer bag completely.
fig. 6 Pull bag cardboard collar to release bag dock
door from connector. Bag dock door will hinge
downward.
fig. 7 Gently pull bag cardboard collar upward out of
the bag dock.
fig. 8 Slide the cardboard collar completely into bag
dock door.
fig. 9 Firmly push bag dock door with both thumbs on
indication point until it snaps.
8 9
PRESS
UNTIL SNAP
IS HEARD
ENFONCEZ JUSQU’À ENTENDRE UN BRUIT
PRESIONE HASTA ESCUCHAR UN CHASQUIDO DE SUJECI ÓN
4
General Information
T o R eplace F ilter
D ust B ag
5
6
1 2 3
7
Upper
Handle
Bag Installation
4
Your ORECK XL vacuum
cleaner has a special
FRESH AIR
® tab pocket.
This light-colored pocket is
located inside the vinyl
bag in the area where the
paper disposable bag
attaches to the intake
tube. Insert tablet in
pocket.
Using An Oreck Fresh Air ® Tab