Onkyo C-705TX - Manual (Page 12)

12
REMOTE
CONTROL
Connecting to the other components
Connecting the connector
If you are using other ONKYO components equipped
with
connectors, you can control these com-
ponents using the amplifier‘s remote controller.
Before connecting
• The amplifier must be connected in the
system hookups for control operations.
• Each component has two connectors. There
is no difference between those connectors.
• The components may be connected in any order.
• Remote control operation is not possible if only
the remote control cable is connected to
the connectors. Connect the audio connec-
tion cables correctly.
The illustration below is the hookup example.
With these hookups, you can operate the CD Syn-
chro Recording (see “CD/MD synchro recording”
on page 8).
C-705TX
Tuner
Cassette Tape Deck
Amplifier
cable
cable
Supplied
cable
Connecting the power cord
Insert the AC power cord into a wall
outlet. The STANDBY indicator lights.
STANDBY
STANDBY/ ON
• To use the unit with the other Onkyo Sepa-
rate Collection series components, follow the
connection diagram in the A-905TX/R-805TX
instruction manual to connect the unit to the
system.
• If you press the (OPEN/CLOSE) button while
the unit is in the STANDBY mode, the power
will turn on and the display will light up auto-
matically.
To wall outlet
Note
An
remote control cable equipped with a 1/
8 in. (3.5mm) diameter miniature two-conductor
phone plug is included with this unit and with ev-
ery tuner and cassette deck that bears the
mark.
Light