Outlaw Audio ECS-10 - Manual (Page 6)

6 Outlaw Audio
Owner’s Manual
To connect an ECS-10 Subwoofer using standard Left/Right preamp
outputs:
1. Turn off all system components and unplug the processor or receiver
and the ECS-10 from their AC power source.
2. Locate the “Left/Right preamp outputs” on the rear panel of your receiver
or processor.
Some audio products that do not offer digital surround processing will
have these types of jacks. If your receiver or processor does not have this
type of output you will need to follow the “Connecting to a system with no
pre-amp outputs” instructions that follow this section.
3. Connect one end of the audio interconnects to the left and right preamp
outputs on the receiver or processor.
4. Locate the connections labeled “INPUT” on the rear panel of the ECS-10
and connect the other end of the interconnects to these jacks.
5. Plug the ECS-10’s power cord into an un-switched AC outlet.
CAUTION: Due to the power requirements of the ECS-10, it must not
be connected to the accessory outlets on a receiver or processor. If a
power-strip or surge protector is used, make certain that it is rated to
accommodate the ECS-10’s power requirements.
6. Reconnect your processor or receiver to the AC power source.
7. Proceed to the “Setting the ECS-10’s Controls” section to learn about
the ECS-10’s controls and how they operate.
Connecting to a System without a Subwoofer
Preamp Output, but with Standard Left/Right
Preamp Outputs
If your system does not have a dedicated subwoofer preamp output, but has left/right
preamp outputs, you can use these jacks to connect your receiver or processor to the
subwoofer amplifier. See Diagram 2 below.
Wiring Diagrams
Diagram 2: Connecting to a System without a Subwoofer Preamp Output,
but with Standard Left/Right Preamp Outputs
ECS-10
Alifi
Riv  
POWER
ON
OFF
R
INPUT
SPEAKER LEVEL INPUT
OUTPUT
LFE
PHASE
LOW-PASS
CROSSOVER
SUBWOOFER
VOLUME
AUTO ON/OFF
SUBWOOFER
DIRECT
INTERNAL
X-OVER
180°
120 Hz
MIN
INACTIVE ACTIVE
MAX
40 Hz
80 Hz
L
R L
+ + - -
120V~
60HZ
8A
ECS-10
CAUTION
RISQUE DE CHOC ÉLECTRIQUE. NE PAS OUVRIR
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS:
CAUTION
RIS
K O
F E LE CT RIC
SH
OC
K
DO NO
T O PE N
AV
IS
: R
IS QU
E DE
C HO
C EL
EC
TR
IQ UE
/N
E PA
S OU
VR
IR
INPUT
SURROUND RIGHT
OUTPUT
+
-
+
-
+
-
+
-
+
-
INPUT
SURROUND LEFT
OUTPUT
INPUT
FRONT RIGHT
OUTPUT
INPUT
CENTER
OUTPUT
INPUT
ON
OFF FRONT LEFT
REMOTE TRIGGER
(POWER ON/OFF)
12V DC
MASTER SWITCH
CIRCUIT BREAKER
15 AMP
120 VAC/60Hz
1800W
WARNING:
HAZARDOUS ENERGY. MAKE PROPER SPEAKER
CONNECTIONS: SEE OWNER'S MANUAL BEFORE USING.
OUTPUT