Olympus SP-620UZ - Manual (Page 67)

67 EN
Monitor Monitor
• Do not push the monitor forcibly; otherwise the image may
become vague, resulting in a playback mode failure or damage
to the monitor.
• A strip of light may appear on the top/bottom of the monitor, but
this is not a malfunction.
• When a subject is viewed diagonally in the camera, the
edges may appear zigzagged on the monitor. This is not a
malfunction; it will be less noticeable in playback mode.
• In places subject to low temperatures, the monitor may take a
long time to turn on or its color may change temporarily. When
using the camera in extremely cold places, it is a good idea to
occasionally place it in a warm place. The monitor exhibiting
poor performance due to low temperatures will recover in
normal temperatures.
• The monitor of this product is manufactured with high-quality
accuracy, however, there may be a stuck or dead pixel on the
monitor. These pixels do not have any infl uence on the image
to be saved. Because of the characteristics, the unevenness
of the color or brightness may also be found depending on the
angle, but this is due to the structure of the monitor. This is not
a malfunction.
Legal and Other Notices Legal and Other Notices
• Olympus makes no representations or warranties regarding
any damages, or benefi t expected by using this unit lawfully,
or any request from a third person, which are caused by the
inappropriate use of this product.
• Olympus makes no representations or warranties regarding
any damages or any benefi t expected by using this unit
lawfully which are caused by erasing picture data.
Disclaimer of Warranty Disclaimer of Warranty
• Olympus makes no representations or warranties, either
expressed or implied, by or concerning any content of these
written materials or software, and in no event shall be liable
for any implied warranty of merchantability or fi tness for any
particular purpose or for any consequential, incidental or
indirect damages (including but not limited to damages for loss
of business profi ts, business interruption and loss of business
information) arising from the use or inability to use these
written materials or software or equipment. Some countries do
not allow the exclusion or limitation of liability for consequential
or incidental damages or of the implied warranty, so the above
limitations may not apply to you.
• Olympus reserves all rights to this manual.
Warning Warning
Unauthorized photographing or use of copyrighted material
may violate applicable copyright laws. Olympus assumes no
responsibility for unauthorized photographing, use or other acts
that infringe upon the rights of copyright owners.
Copyright Notice Copyright Notice
All rights reserved. No part of these written materials or this
software may be reproduced or used in any form or by any
means, electronic or mechanical, including photocopying and
recording or the use of any type of information storage and
retrieval system, without the prior written permission of Olympus.
No liability is assumed with respect to the use of the information
contained in these written materials or software, or for damages
resulting from the use of the information contained therein.
Olympus reserves the right to alter the features and contents of
this publication or software without obligation or advance notice.
FCC Notice FCC Notice
• Radio and Television Interference
• Changes or modifi cations not expressly approved by the
manufacturer may void the user’s authority to operate this
equipment. This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a
residential installation.
• This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications.
• However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
• Adjust or relocate the receiving antenna.
• Increase the distance between the camera and receiver.
• Connect the equipment to an outlet on a circuit different from
that to which the receiver is connected.
• Consult your dealer or an experienced radio/TV technician
for help. Only the OLYMPUS-supplied USB cable should
be used to connect the camera to USB enabled personal
computers (PC).
Any unauthorized changes or modifi cations to this equipment
would void the user’s authority to operate it.