Sylvania 6620 LDF - Manual (Page 10)

IF YOU HAVE A JACK ON THE WALL
Connect the TV to the wall-mounted antenna jack
with on RF cable (commercially available).
IF YOU HAVE A WIRED CABLE
Connect the TV to the wired antenna cable.
•
Before plugging the antenna into the ANT. jack of the
unit, check that the pin is not bent. If it is bent,
straighten the pin as illustrated, then plug the pin into
the ANT. jack of the unit.
• Cables used here are commercially available.
• For your safety and to avoid damages to the unit, unplug the antenna cable from the ANT. jack
before moving the unit.
NOTE
- 10 - EN
P
REPARATION FOR USE
ANTENNA/CABLE CONNECTION
- ANTENNA/CABLE CONNECTION
DI GI TA L
AU DI O OU T
(C OA XI AL )
R
L
Y
Pb
Pr
R
L
VID EO
S-V ID EO
VIDEO2
CPMPONENT
AUDIO
AUDIO
VIDEO1
AN T
HE AD PH ON E
RF Cable
[Rear of this unit]
from Cable Company
or Satellite Antennna
ANT
DI GI TA L
AU DI O OU T
(C OA XI AL )
R
L
Y
Pb
Pr
R
L
VIDE O
S-V ID EO
VIDEO2
CPMPONENT
AUDIO
AUDIO
VIDEO1
ANT
HEAD PHO
NE
ANT
OUT IN
75-ohm
Coaxial Cable
Cable Box
or Satellite Box
[Rear of this unit]
from Cable Company
or Satellite Antenna
For CATV system installer:
•
This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides
guidelines for proper grounding and in particular, specifies that the cable ground shall be connected to the grounding
system of the building as close to the point of cable entry as practical.
NOTE
Bent pin
Cable
Plug
(Needs to be
straightened)
(Straight pin)
NOTE
WHEN USING CABLE BOX/SATELLITE
BOX
If your cable service supplies you with a converter
box or if you use a satellite system, you can use the
basic connection shown above.
Channel selection must be made with the converter
box or satellite box. This means that channels cannot
be changed using the remote control of this unit.
- CABLE/SATELLITE BOX CONNECTION