Sylvania 6520FDG - Manual (Page 6)

EN
6
P
REPARATION FOR USE
ANTENNA/CABLE CONNECTIONS
ANT. COAXIAL
ANT.
Cable
TV signal
Antenna
or
IN OUT
Rear of the unit
*NOTE
(DO NOT DISCONNECT FROM BOX)
Some cable TV systems use scrambled
signals and require a special converter to
receive these channels. Consult your local
cable company.
OR
Incoming cable from home
Antenna / Cable Company
(No Cable Box)
Incoming cable from Cable Company
or Satellite Antenna
Cable Box or Satellite Box*
NOTE:
Before plugging the antenna into
the ANT. jack of the unit, check
that the pin is not bent. If it is bent,
straighten the pin as illustrated,
then plug the pin into the ANT. jack
of the unit.
Bent pin
Cable
Plug
(Needs to be
straightened)
(Straight pin)
For your safety and to
avoid damages to the unit,
unplug the antenna cable
from the ANT. jack before
moving the unit.
When you watch a program recorded on another source (VCR or video camera), use the
AUDIO/VIDEO input jacks on the front of the unit.
Connect the Audio/Video output jacks of another source to the AUDIO L/R and VIDEO
jacks of this unit.
Then use [SELECT] or [CH. K
K / L L ] until "AUX" appears on the screen.
POWER
VOLUME CH.
SELECT
STOP PLAY
OPEN / CLOSE
VIDEO HEADPHONE L - AUDIO - R
L - AUDIO - R
OPEN / CLOSE
VIDEO HEADPHONE
ex.
VCR or video camera, etc.
NOTE:
When you connect a monaural VCR (another source) to this unit, connect the Audio output jack of the monaural VCR
(another source) to the AUDIO L jack of this unit. The audio will output in both L and R channel equally.
AUX
CONNECTING TO AN EXTERNAL DEVICE (FRONT)
Plug the incoming cable into the ANT. jack on the rear of the unit.
If your cable service supplies you with a converter box or if you use a satellite system, connect the box with
this unit as shown below.
[Front of the unit]
To the Audio output jacks
To the Video output jack
(OUT)
(IN)
(OUT)
(IN)
Audio Cable
(commercially available)
Video Cable
(commercially available)
T9200UA(EN).QX3 06.2.6 11:39 AM Page 6