Troubleshooting – Olympus MR-500i User Manual
Page 106
106
Additiona
l Infor
m
a
tio
n
Troubleshooting
6
Tape the cable to the battery body, and put the battery in a plastic bag, etc.
Cover the connector with tape before you put the battery in a plastic bag.
Troubleshooting
Before sending the product for repair, refer to the following checklist to resolve the problem. If the problem
persists, contact your nearest Olympus service center.
In addition, be sure to back up the data before sending this product for repair or service. Writing to the hard disk
or deleting data, etc., may be necessary during the repair or service.
Due to copyright restrictions, we cannot copy stored data for repair or service. Restoring the data is not
available. We also recommend backing up your data often, by synchronization, to prevent data loss problems.
Notes
• Check that the battery is completely drained before removing it.
• Make sure that your m:robe is turned off before removing the battery.
• Do not reuse the battery once it has been removed.
• At your earliest opportunity, return the removed built-in battery to a recycling location.
• When you dispose of this product, you should obey local ordinance or rule of your municipality. For details, contact your
local authority.
Problem
Cause
Solution
Page
The power
cannot be turned
on.
The battery is empty.
Charge the battery with the supplied AC
adapter.
The operation of the device is
unstable.
Reboot the device.
The power turns
off automatically.
Off Timer is set.
The power turns off automatically after
the preset time of the Off Timer has
elapsed. Set to “OFF” to disable the Off
Timer setting.
The Auto Off function is
activated.
If playback of music, slide show or
remix is stopped and no operation is
performed for more than 10 minutes,
the device automatically turns off. Turn
on the device by pressing POWER.
The battery is discharged.
Charge the battery with the supplied AC
adapter.
00MR500i_E.book Page 106 Thursday, November 4, 2004 6:22 PM