Omega A2400 - Manual (Page 32)

Command Set 4-11
In this example the ‘30’ and ‘31’ are the hex ASCII codes for the characters
‘0’ and ‘1’ respectively. The Extended Address is ‘01’.
Read Identification (RID)
The Read IDentification command reads back the user data stored by the
IDentification (ID) command. The ID and RID commands are provided as a
convenience to the user to store up to 16 characters of information in the
A2400 EEPROM. The stored information could be anything from the date of
installation to a device tag indicating where the device is positioned in a
system.
Command: $1RID
Response: * TANK FARM 1
Command: #1RID
Response: *1RID TANK FARM 11F
Read Long Prompt(RLP)
The Read Long Prompt command reads back the extended addressing long
form command prompt stored in the module’s nonvolatile memory with the
Long Prompt (LP) command. The response to the RLP command is a two
character hex value of the ASCII long form prompt character.
Command: $1RLP
Response: *7D (7D = } = Factory Setup)
Command: #1RLP
Response: *1RLP7DC4
Remote Reset (RR)
The Remote Reset (RR) command allows the host computer to perform a
program reset on the module’s microprocessor. This may be necessary if
the module’s internal program is disrupted by static or other electrical
disturbances. Once a reset command is received, the A2400 will read the
setup information and delay values from EEPROM and activate the read
values.
Command: $1RR
Response: *