Connecting the av receiver —continued – Onkyo 29344937 User Manual

Page 20

Advertising
background image

20

Connecting the AV receiver

—Continued

Connecting the Speaker Cables

Terminal posts

Push terminals

The following illustration shows which speaker should be connected to each pair of terminals for up to 7.1-channel
playback.

If you’re using only one surround back speaker, connect it to the power amplifier’s left terminals.

Notes:
• The speakers are configured by using the “Speaker Settings” on page 44 and “Speaker Setup” on page 68.
• When you connect the front high left and right speakers, preparate it sepalately.

1

Strip 1/2"-5/8" (12-
15 mm) of insulation
from the ends of the
speaker cables. (Supplied
speaker cables are already
stripped.)

2

Unscrew the terminal. Fully insert the bare wire,
making sure that it’s touching the threaded shaft
in the center. Screw the terminal tight.

1/2"-5/8" (12-15 mm)

1

Strip 3/8"-1/2"
(10-12 mm) of insulation
from the ends of the
speaker cables, and twist
the bare wires tightly, as
shown.

2

While pressing the lever, insert
the wire into the hole, and then
release the lever.
Make sure that the terminals are
gripping the bare wires, not the
insulation.

3/8"-1/2" (10-12 mm)

Surround

right

speaker

Front right

speaker

Front left

speaker

Surround

back left

speaker

Surround

left

speaker

Surround

back right

speaker

Center

speaker

Front high

right speaker

(Optional)

Front high

left speaker

(Optional)

Powered

Subwoofer

Brown

Tan

Blue

Gray

Green

Red

White

Advertising
This manual is related to the following products: