Omnimount TILT-PA - Manual (Page 3)

10
Step 7 — Attaching the UM1 to the Display
1. Thread Mounting Screw through Square Washer, Rail, Spacer (if needed),
and into the Display’s Mounting Holes.
Mounting
Screw
Display
Spacer
(if needed)
Square
Washer
NOTE: Ensure Retaining Screws are loose enough to allow for adjustment
2. Center the Back Plate on the Display and securely tighten the Retaining
Screws and Mounting Screws
Back
Plate
Important
DO NOT over tighten the mounting screws, or the display may be damaged.
NEVER use a power driver to tighten the mounting screws.
3
Extended Rails
Standard Rails
Back Plate
Channel
Required Tools:
Ratchet and 5/16” Deep Socket
or
5/16” Open Wrench
or
Adjustable Spanner Wrench
Large Universal Adapter Component Guide