Sylvania DVR95DF - Manual (Page 16)

Connection to a cable box or satellite box
Connections
14
Note to the Cable TV System Installer :
This reminder is provided to call the Cable TV system installer’s attention to Article 820-40 of the
National Electrical Code, which provides guidelines for proper grounding - in particular, specifying that the
cable ground shall be connected to the grounding system of the building, as close to the point of cable
entry as possible.
With this setup:
• You can record any unscrambled channel by selecting the channel on the cable box or satellite box. Be sure
that the cable box or satellite box is turned on.
• You cannot record one channel while watching another channel.
ANTENNA AUDIO IN
VIDEO IN
L
R
AUDIO OUT
VIDEO OUT
(L1)
IN
IN
OUT
OUT
S-VIDEO
COMPONENT
VIDEO OUTPUT
L
Y
PB/CB
PR/CR
R
DIGITAL AUDIO OUTPUT
PCM / BITSTREAM
COAXIAL
AUDIO IN VIDEO
RF cable
(supplied)
Video
cable
(supplied)
Audio
cable
(supplied)
(Back of TV)
Cable
TV signal
Connect
Connect
Connect Connect
(Back of this unit)
2
1
3 4
IN OUT
(Cable box or
Satellite box)
RF cable
If your TV is compatible with Progressive Scan (525p / 480p) and you want
to enjoy that high quality picture;
You must select the connection Method 2 on page
13 and Progressive Scan mode.To set
the mode, press and hold [SETUP] on the remote control for more than 3 seconds
during DVD playback, so that “P.SCAN” will appear on the display of this unit.
If your TV is not compatible with Progressive Scan;
Use this unit in Interlace mode. Make sure that no “P.SCAN” is on the display of this unit.
If not, press and hold [SETUP] on the remote control for more than 3 seconds during
DVD playback, so that “P.SCAN” on the display of this unit will disappear.
DISPLAY SETUP
TOP MENU MENU/LIST
REPEAT
CLEAR
7 8 9
SPACE
0
ENTER RETURN
PQRS TUV WXYZ
K
more than 3 seconds
during DVD playback
[Interlace mode]
[Progressive Scan mode]
Connection to a TV (cont’d)
E6701UD_ENSP.qx3 05.4.26 12:01 Page 14