Odyssey Electronics Building Set - Manual (Page 11)

Tender rear coupler
releases.
Coupler release sounds.
11
Press AUX2 to turn
your locomotive’s
headlight on and off.
Press WSTL/HRN to
activate the locomotive’s
whistle, release to
discontinue. Multi-Whistle steam
whistle sound.
Press DIR—the loco-
motive decelerates to a
complete stop; turn the
throttle up, and the locomotive
moves in the opposite direction.
There is no neutral. Steam air-
release sound.
Press BELL once to
activate the bell, again
to discontinue.
Traditional bell sound.
Press HALT to shut down all
PowerMaster electrical
output on your railroad.
Stops all Command-equipped Lionels
in operation.
NOTE: Use “HALT” only in “emer-
gency” situations.
Turn the THROTTLE
to the right to accel-
erate, left to deceler-
ate. Speed-depen-
dent variable steam
chuffing. DynaChuff
dynamic chuffing effect.
CAB-1 commands for your locomotive
Press and hold BOOST
for extra power. Release
BOOST and return to the
locomotive’s previous speed.
Labored chuff.
Press and hold BRAKE to
slow down or stop.
Release BRAKE and
return to the previous speed.
Squealing brake sounds.
Locomotive
RailSounds effects
in bold italic.
Coupler release
sounds.
Running your locomotive in the TrainMaster
Command environment
Y our Command-equipped loco-
motive comes factory-pro-
grammed with an ID# of “1.” To get
your locomotive into action, set
PowerMasters to CMD or set all power
supplies on full. Press ENG and “1”
on CAB-1. Turn the throttle or press
any command button; RailSounds
starts up. Your locomotive is ready
for Command operations.
Address Locomotive #1
PowerMasters set to CMD or traditional
power supplies ON FULL
Press ENG
Press 1 (the ID#)
Throttle up/press any command button
Example
TrainMaster Command operations