Optimus STS 200 - Manual

© 1996 Tandy Corporation.
All Rights Reserved.
Optimus is a registered trademark used by Tandy Corporation
RadioShack is a trademark used by Tandy Corporation.
Cat. No. 40-4073
STS 200 Speaker System
Your Optimus STS 200 Speaker Sys-
tem has a 3-way acoustic suspension
design that utilizes a high compliant
10-inch woofer for excellent low-end
response characterized by tight, clean
bass. The specially treated 5-inch
midrange and
3 /
4
-inch wide angle dis-
persion dome tweeter mesh seam-
lessly to provide extremely clean vocal
and high frequency production.
The speaker cabinet is solid in
construction and is finished in
woodgrain vinyl. The decorative
grille is acoustically transparent.
Note: You need speaker wire (not
supplied) to connect your speaker.
SPEAKER PLACEMENT
Cautions:
• To prevent the cabinet from warp-
ing or discoloring, do not place the
speaker where it is exposed to
direct sunlight or excessive hu-
midity.
• Do not place the speaker where it
might be knocked over or hit by
falling objects.
Where and how you position each
STS-200 speaker has a great effect
on the overall performance of your
sound system.
For the best sound and stereo effect,
place the speakers so the distance
between them is about the same as
the distance between the listening
area and a point halfway between the
speakers.
If you place the speakers too far apart,
a sound “hole” could occur and you
might not get the proper stereo image
in the listening area. Compensate for
this by angling the speakers slightly in
toward the listening area.
If you place the speakers too close to-
gether, you could cancel out the ste-
reo image and the sound might seem
to be monaural. Compensate for this
by angling the speakers slightly away
from the listening area.
a = b
a
b
40-4073.fm Page 1 Wednesday, August 11, 1999 10:25 AM