Omega Vehicle Security LDP63100 - Manual (Page 8)

8
z LIGHT-WEIGHT ALUMINUM CONSTRUCTION
z COMPLETELY SEALED FOR WASH-DOWN
z MOUNTING CHANNELS FOR VERSATILE INSTALLATION
DESCRIPTION
The NEMA 4/IP65 Large Display Enclosure is designed to protect the
LDP63100 from dust and hose directed water, when properly installed. This
light-weight all aluminum unit utilizes welded seams and neoprene gaskets to
meet NEMA 4/IP65 requirements. A textured, polyurethane coating protects
against corrosion and is scratch resistant. Figure 1 below shows the overall
dimensions of the Enclosure. The Display Enclosure with Mounting Channels
weighs 9 pounds (4.1 Kg).
DIMENSIONS In inches (mm) MOUNTING
Provided with the enclosure are two ¼-20 UNC x 1" hex
bolts, two ¼-20 UNC “strut nuts”, and two ¼" washers. The
“strut nuts” can be installed anywhere in the channel by
inserting them, spring side down, into the channels, then
rotating them 90 degrees clockwise until the notches engage
with the lips of the channel. The bolts and washers provided
allow mounting to surfaces ¼" to ½" thick (6.4 to 12.7 mm).
Use longer bolts for mounting to thicker surfaces. Bolts
fabricated from materials other than steel are not recommended.
* Housing Only ** Overall Including Screwheads
Figure 1 Figure 3
TYPICAL INSTALLATIONS FOR NEMA 4/IP65 ENCLOSURE
Figure 2
NEMA 4/IP65 LARGE DISPLAY ENCLOSURE & SHROUD FOR LDP63100
BASEMOUNT WITH WATERTIGHT
CABLE CONNECTOR ENTERING
THROUGH REAR PANEL.
Removing the rear panel of the enclosure allows access to the Display for
service. Either the rear panel or housing may be drilled to accept sealed conduit
fittings, liquid-tight cable fittings or other types of wiring connectors. The
enclosure may be attached to horizontal surfaces located above or below it,
using the mounting channels provided.
SUSPENDED FROM CONDUIT
WITH SEALED FITTINGS.
(SHOWN WITH SHROUD).
BEAM MOUNT WITH SEALED
CONDUIT ENTERING FROM
RIGHT SIDE.
Picture includes the LDP63100, NEMA Enclosure, and Shroud