Optimus 12-2154 - Manual (Page 10)

10
1. Connect the gray wire to the right
front speaker’s positive terminal.
This terminal is usually marked
with a plus (+) sign or red mark.
2. Connect the gray/black wire to the
right front speaker’s negative ter-
minal. This terminal might be
marked with a minus (
– ) sign or it
might not be marked at all.
3. Connect the white wire to the left
front speaker’s positive terminal.
4. Connect the white/black wire to
the left front speaker’s negative
terminal.
5. Connect the violet wire to the right
rear speaker’s positive terminal.
6. Connect the violet/black wire to
the right rear speaker’s negative
terminal.
7. Connect the green wire to the left
rear speaker’s positive terminal.
8. Connect the green/black wire to
the left rear speaker’s negative
terminal.
Connecting One Pair of
Speakers
For 12-2155: If you are using only one
pair of speakers, follow Steps 1
– 4 in
“Connecting Two Pairs of Speakers”
on Page 9 to connect the harness with
the 14-pin connector to the speakers.
For 12-2154: If you are using only one
pair of speakers, remove the tape that
holds the mounting sleeve in place
and slide the sleeve off of the stereo.
Then set
2CH/4CH on the bottom of
the stereo to 2CH . Then follow these
steps to connect the harness with the
14-pin connector to the speakers.
(illus)
(illus)
(illus)
12-2154.fm Page 10 Wednesday, July 14, 1999 3:34 PM