Onkyo DV-SP506 - Manual (Page 15)

15
Front & Rear Panels —Continued
A OPTICAL DIGITAL AUDIO OUTPUT [21, 22]
This optical digital audio output can be connected to
an optical digital audio input on a hi-fi amp, AV
receiver, or surround sound decoder (Dolby Digital,
DTS).
B COAXIAL DIGITAL AUDIO OUTPUT [21, 22]
This coaxial digital audio output can be connected
to a coaxial digital audio input on a hi-fi amp, AV
receiver, or surround sound decoder (Dolby Digital,
DTS) with supplied coaxial digital cable.
C HDMI OUT [19–23]
This HDMI jack outputs digital video and audio and
can be connected to an HDMI input on a compatible
TV or other component.
D S VIDEO OUTPUT [22, 23]
This connector can be used to connect a TV or pro-
jector with an S-Video input.
E VIDEO OUTPUT [22, 23]
This RCA connector can be used to connect a TV or
projector with a composite video input.
F COMPONENT VIDEO OUTPUT [22, 23]
These jacks output component video and can be
connected to an component video input on a TV or
projector.
G RS 232 (North American model only)
This port is for servicing.
H jack [28]
These (Remote Interactive) connectors can be
connected to the connectors on your other
Onkyo AV components for interactive control.
Connecting an
cable only does not make the
system operational. You must also connect the audio
cables as well.
If you’re using RIHD, do not connect anything to
these connectors.
I AUDIO OUTPUT [21–23]
These jacks make up the multichannel analog audio
output. The D.MIX/FRONT jacks can be connected
to a stereo input on a TV, hi-fi amp, or other compo-
nent. The 1 and 2 jacks output the same signals, so
use either pair. If you use this connection, in the
Speaker Configuration (page 52), set the Sub-
woofer, Center Speaker, and Surround Speaker set-
tings to Off, so that 5.1-channel DVD audio is down
mixed into two channels.
If you’re using an AV receiver or surround decoder
with a 5.1-channel analog audio input, use the
D.MIX/FRONT 2 jacks and the SURR 1 L/R, CEN-
TER, and SUBWOOFER jacks.
If you’re using an AV receiver or surround decoder
with a 7.1-channel analog audio input, connect the
SURR 2 L/R jacks to the surround back L/R input
jacks on your AV receiver or decoder, and set the
SURR MODE switch to “1+2.” The SURR 1 and
SURR 2 jacks output the same signals.
J SURR MODE switch [28]
This switch is used to turn the AUDIO OUTPUT
SURR 2 on or off. To use this output, set the switch
to “1+2.” The SURR 2 jacks output the same signals
as the SURR 1 jacks.
K AC INLET [29]
The supplied power cord is connected here. The
other of the power cord should be connected to a
suitable wall outlet.
L AV CONNECTOR (European model only) [28]
This SCART output can be connected to a TV or
projector with a SCART input. This SCART con-
nector outputs 2-channel stereo audio (same signals
as the D.MIX/FRONT jacks), composite video,
S-Video, and RGB video.