Oki 490 - Manual (Page 25)

Using Your Printer 25
Printer Reset
Clearing some error conditions requires that you reset
(reinitialize) the printer. To do this:
1 Press and release SEL (1) to take the printer off-line.
The SEL light goes out.
2 Press and hold SHIFT (2), then press RESET / CHARACTER
PITCH .
Important!
Pressing
SHIFT + RESET reinitializes the printer, but does not
affect any menu settings and does not reset the printer to the
factory defaults. For information on resetting the printer to
the factory defaults, see “Resetting the Menu to the Factory
Defaults” later in this chapter.
Emulations
• Epson ® LQ — factory setting
• IBM ® Proprinter
• IBM ® AGM
Changing Emulations
1 Make sure paper is loaded.
2 Press and hold SHIFT (2), then press SEL (1).
3 Press LF (3).
The following line prints:
Printer Control Emulation Mode EPSON LQ
4 Press TEAR (4) repeatedly until the emulation you wish to
select prints in the right-hand column.
5 Press and hold SHIFT (2), then press SEL (1) to save your
setting and exit the Menu Mode.