Onkyo TX-SR500E - Manual (Page 5)

5
Before using the unit
30˚
30˚
16 feet (5m)
Remote control sensor
REMOTE
CONTROL
R
L
R
L
R
L IN IN IN COAXIAL OPTICAL 1 2
IN IN IN IN FRONT SURR CENTER
SUB WOOFER VIDEO 2 VIDEO 1
OUT
OUT OUT
DIGITAL INPUT VIDEO 2 VIDEO 1 DVD MONITOR OUT
VIDEO
S VIDEO
DVD TAPE CD
FRONT SPEAKERS A FRONT SPEAKERS B SURROUND SPEAKERS
CENTER
SPEAKER
L
R
L
R
AC OUTLET
120 V
VOLTAGE SELECTOR
220-230 V
ANTENNA FM 75 AM
SUBWOOFER PRE OUT
120 V
VOLTAGE
SELECTOR
220-230 V
STANDBY indicator
Receiver
Setting the voltage selector (Worldwide models
only)
Worldwide models are equipped with a voltage selector to conform
with local power supplies. Be sure to set this switch to match the
voltage of the power supply in your area before plugging in the unit.
Determine the proper voltage for your area: 220-230 V or 120 V. If
the preset voltage is not correct for your area, insert a screwdriver
into the groove in the switch. Slide the switch all the way to the
upper (120 V) or to the lower (220-230 V), whichever is appropriate.
Setting the AM tuning step frequency
(Worldwide models only)
Refer to page 24 to set the AM tuning step frequency correctly.
Inserting the batteries
1 Detach the battery cover.
2 Insert the two size AA/R6/UM3 batteries.
Be sure to match the + and – ends of the batteries with the
diagram inside the battery compartment.
3 Attach the battery cover.
Notes
• Do not mix new batteries with old batteries or different kinds of
batteries.
• To avoid corrosion, remove the batteries if the remote
controller is not to be used for a long time.
• Remove dead batteries immediately to avoid damage from
corrosion. If the remote controller does not operate smoothly,
replace both batteries at the same time.
• The life of the supplied batteries is about six months but this
varies depending on usage.
Using the remote controller
Point the remote controller toward the remote control sensor. The
STANDBY indicator lights up when the unit receives a signal from
the remote controller.
Notes
• Place the unit away from strong light such as direct sunlight or
inverted fluorescent light which can prevent proper operation
of the remote controller.
• Using another remote controller of the same type in the same
room or using the unit near equipment which uses infrared rays
may cause operational interference.
• Do not put any object (such as a book) on the remote controller.
The buttons of the remote controller may be pressed by mistake
and drain the batteries.
• Make sure the audio rack doors do not have colored glass.
Placing the unit behind such doors may prevent proper remote
controller operation.
• If there is any obstacle between the remote controller and the
remote control sensor, the remote controller will not operate.