Specifications- isis 215sb – QSC Audio ISIS 215PCM User Manual
Page 33
33
Specifications- ISIS 215SB
215SB Specifications
Frequency Range
Recommended Bandpass:
35- 150 Hz (±3 dB)
Frequency Response:
36- 360 Hz (-3dB)
Usable Frequency Range:
29- 440 Hz (-10 dB)
Maximum Output
Calculated Peak Output
1
:
141 dB SPL
Measured Continuous Output
2
:
131 dB SPL
Continuous Noise Exposure Level
3
:
122 dBA
Impedance:
4 ohms (nom.) 3.7 ohms (min.) 23.3 ohms (max.)
Power Handling
4
:
1300 W RMS, 2 hours (AES)
1000 W RMS, 8 hours (IEC)
800 W RMS, 100 hours (IEC)
Sensitivity:
101 dB half-space, 95 dB full space, 35- 100 Hz, 1 W, 1 m
Connector:
Neutrik NL4MP
Wiring of Connector:
Standard Bridge Mono Wiring.
Pin 1+ = Positive Input Signal
Pin 1– = Negative Input Signal
Nominal Coverage:
Omnidirectional (100 Hz).
Transducers:
Two 15-inch (394 mm) high efficiency subwoofer drivers.
4-inch (100 mm) voice coil, copper on fiberglass former.
High excursion, multi-vented voice coil design.
Enclosure Type:
High efficiency horn-ported box hybrid, tuned to 35 Hz.
Material: Composilite cored construction.
Dimensions:
40” W x 26” H x 25” D., nominal (102 x 66 x 64 mm). Refer to drawing for details.
Weight:
175 pounds (79.4 kg)
Features:
Weather-resistant enclosure
Durable rubber anti-skid feet on two sides of cabinet
Pole Cups:
Three 2-inch diameter, 6-inch deep, aluminum. Refer to drawing.
Flying Points:
Four 16-inch “L-track” rails at corners. Refer to drawing.
Notes:
1- Calculated maximum peak SPL at 1 meter distance, half-space, speaker operating at rated RMS power with 6 dB crest factor pink noise
input, 35- 100 Hertz.
2- Measured maximum RMS SPL referenced to 1 meter distance, loudspeaker operating at rated RMS power with 6 dB crest factor pink
noise input, 35- 100 Hertz. Measurement taken at 2 meters, half-space, after 15 minutes of full power operation.
3- Maximum continuous SPL at 1 meter in dBA. The dBA scale is typically used to identify sound sources which have the potential to cause
permanent hearing loss.
4- Maximum input power tested in accordance with AES and/or IEC recommendations, 35- 100 Hertz band limiting, 6 dB signal crest factor.
5- QSC DSP configurations available at http://www.qscaudio.com. Parameters for alternative processing hardware available upon request.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE