Quinny 01473 - Manual (Page 6)

To Use as a Carriage
4
To install carrier onto
stroller:
1
Adjust the connection
points using the button
at the center. Be sure
the connection points
are positioned straight
up (Figure 1).
2
The adapters and
corresponding
connection points are
marked with an
“L” (left) and
“R” (right).
Insert the adapter
marked “R” into
the connection
point marked “R”
until you hear a “click”
(Figure 2).
Do the
same for those marked
“L”. Check to make
sure they are securely
fastened by pulling up
on them.
To remove carrier from
stroller:
4
Press both release but-
tons inside canopy (1)
while pulling up on the
carrier (2) (Figure 4).
5
To remove the adapters,
press the button (1) on
the inside and pull the
adapter out (2) (Figure 5).
3
Position the carrier with
the foot of the carrier
toward the handlebars
as shown (Figure 3).
Place the carrier on the
adapters until you hear
a “click.”
Pull up on the carrier
handle to ensure it is
securely in place. The
carrier should not release
without pushing the
release buttons.
To use the Dreami TM in the Buzz TM stroller:
NOTE: Read the Buzz TM Stroller User Guide to remove the
seat from the stroller frame.
1
2
3
4
5