Quatech DSP-100 - Manual (Page 38)

6 Windows NT
6.1 Installing DSP-100 Under Windows NT
To allow easy configuration of the DSP-100 the Quatech Device Manager for Windows
NT has been written for the hardware. This configuration utility supports the DSP-100
only in block addressing mode.
To begin the installation, open Windows Explorer and search for the ‘Setup.exe’
command to install the Quatech Device Manager. <See following Windows Explorer
figure.> (D:\Serial Port Adapters\Drivers\Windows NT 4.0 for PCI, PCMCIA,ISA).
Once the installation is complete an icon will be placed on the desktop.
Windows NT Explorer
DSP-100 User's Manual 32