Quantum Audio QCA4400 - Manual (Page 6)

S
PEAKER CONNECTIONS (QCA4400)
Make the speaker connections using speaker wire that is at least 16
gauge or heavier.
As with any audio component, proper phasing of the amplifier and speakers is essential for
strong bass response. When connecting, make sure that positive (+) from the amplifier is
connected to the positive (+) of the speaker, and the same for negative (-).
*** CAUTION! In the bridged mode, the amplifier must see a 4 Ohm load or higher. Any
lower than 4 ohms will cause the amplifier to overheat and possible cause permanent
damage to the amplifier!
R
EMOTE BASS CONTROL MODULE (OPTIONAL)
(QCA2500D QCA3500D QCA4500D)
Before connecting the remote, it will be necessary to find a mounting location that will be
easy to access for adjustment. Once you select your mounting location, you will need to run
the control wire from the remote to the amplifier. To avoid possibility of induced noise from
the car’s electrical system (i.e. popping noises or engine noise), run the cable from the
remote to the amplifier away from the car’s electrical wiring.
10 9
Ch4- Ch4+ Ch3- Ch3+ Ch2- Ch2+ Ch1- Ch1+ POWER
PROTECT
BRIDGE MODE BRIDGE MODE
www.QuantumAudio.net
FUSES +12V REM GND
SPEAKER OUTPUT
800 Watts Dynamic Power
4 Channel Amplifier
QC4400
+ - + -
4 Ohm Speaker 4 Ohm Speaker
Ch4- Ch4+ Ch3- Ch3+ Ch2- Ch2+ Ch1- Ch1+ POWER
PROTECT
BRIDGE MODE BRIDGE MODE
www.QuantumAudio.net
FUSES +12V REM GND
SPEAKER OUTPUT
800 Watts Dynamic Power 4 Channel Amplifier
QC4400
4 Ohm Speaker 4 Ohm Speaker 4 Ohm Speaker 4 Ohm Speaker
+ - + - + - - +
POWER
Min
Max
REMOTE
LEVEL
IN OUT
MIN MAX 20Hz 50Hz 40Hz 130Hz 0dB 18dB
SUBSONIC LPF
BASS
BOOST
www.QuantumAudio.net 4500 Watts Dynamic Power Class D Monoblock Amplifier
QCA4500D