Quatech DSCLP-100 - Manual (Page 30)

6.3.1 QTPCI.EXE
Quatech's "QTPCI" utility supplies the information required when
modifying the serial port settings of the application. This program should be run
from real DOS, not in a Windows DOS box.
Figure 14 shows the Basic Mode display for the DSCLP-100 after the "Q"
key has been pressed. In this example, the DSCLP-100 uses I/O base address
FF80 hex and IRQ 11. The hardware revision of the DSCLP-100 is also
displayed. Pressing the "N" key will show similar information for all
non-Quatech PCI devices in the system, including those devices integrated on the
motherboard.
The QTPCI program is capable only of displaying the PCI configuration. It
cannot be used to make changes.
Figure 14 --- QTPCI.EXE Basic Mode display
30 DSCLP/SSCLP-100 User's Manual