QSC Audio I-YM8 - Manual (Page 6)

EN
6
Optional I-YM8 Accessory Kit
The I-YM8 Accessory Kit includes a yoke mount bracket, two loud-
speaker retaining knobs, two swivel feet with retaining knobs,
mic stand adapter, pole cup and retaining knob.
The I-YM8 Accessory Kit enables you to mount the loudspeaker to
most any surface using the yoke mount bracket, or use as a floor
monitor by attaching the two swivel feet. If wall mounting the
yoke, we recommend removing the swivel feet. The yoke mount
bracket may be attached to the pole cup, mic stand adapter, or a
standard truss clamp.
Floor Monitor Use
Attach the two swivel feet using the retaining knobs provided.
Use any of the holes along the centerline of the bracket, one
toward each end. Rotate the feet into place and tighten the knobs
to prevent rattling. Attach the loudspeaker and secure in place
with the large retaining knobs.
Pole Cup Use
For pole cup use, attach the pole cup to the yoke mount bracket.
Use the intermediate-sized retaining knob to secure the adapter
to the yoke using the large hole in the center of the bracket.
Attach the loudspeaker and secure in place with the large retain-
ing knobs. Make sure the swivel feet are tight or removed com-
pletely to prevent rattling.
IMPORTANT! ENSURE THE LOUDSPEAKER IS
MOUNTED PROPERLY AND A SAFETY CABLE IS
INSTALLED TO RETAIN THE LOUDSPEAKER IN THE
EVENT OF A MOUNTING FAILURE.
Ensure the mounting surface and supporting struc-
ture are strong enough to support the loudspeaker
assembly during any potential vibration or seismic
activity.
Attach a safety cable to the attachment point on the
bottom-back of the loudspeaker. Ensure the safety
cable, cable attachment technique, securing hard-
ware, and attachment points are strong enough to
support several times the weight of the loud-
speaker in the event of a primary-mount failure.