Quantum DX - Manual (Page 6)

6 Basic Operation Instructions DX Scanner
SELECT MODE
1. Press the On/Off Button on the DX compatible Master Remote used on
your power chair. The Module Status LED on the Scanner will light up,
indicating that it is in Standby Mode and ready for use.
2. Press the Select Switch once to activate the Scanner. All three Mode
LEDs will light up.
3. After power up, the Scanner will begin running through the three modes—
Drive, Seat, and Environmental. Each Mode LED will light up in
sequence. To choose a mode, you must wait for its LED to light up, then
press the Select Switch.
Figure 2. Directional LEDs
DRIVE MODE
1. Press the Select Switch when the Drive Mode LED is lit. Once selected,
the Scanner will cycle through the available drive directions.
NOTE: If the Select Switch is not pressed within three scanning cycles
of the Drive Mode, the Scanner will exit that mode.
NOTE: The Scanner will run through each Mode LED five (5) times
before returning to Standby Mode.
2. To move in any direction, wait
until the desired Directional LED
is lit, then press and hold down
the Select Switch to move your
power chair in that direction. The
Scanner will automatically return
to the Forward Direction LED
after any power chair movement.
See figure 2.