Quantum Data 802R-PCI - Manual (Page 6)

2 Chapter 1 Getting Started
Installing generator
To install the generator:
1. Turn off your computer and monitor to protect the generator from possible electrical
damage. Leave the power cord connected with the computer, until step 4.
2. Remove the cover from the computer.
3. Touch the metal part of the power supply case inside the computer to discharge any
static electricity that you might have.
4. Disconnect the power cord from the computer, even though the computer is turned off.
5. Hold the generator by its edges, and insert it into a PCI slot.
6. Secure the backplate attached to the card.
7. Replace the computer cover, and plug in the computer.
8. Connect a display with the generator.
9. Turn on the computer.
The generator displays the SMPTE133 image, using the DMT0660 format, the first time
it is started, or initialized.