Toshiba WX800U - Manual (Page 37)

37
Chapter 6: Basic features
Elements of the Channel Browser ™
1 Current list (History, ANT/CABLE, Inputs, or
REGZA-LINK
)
2 Input type
3 Channel or input currently being viewed
4 Channel or input that is currently highlighted in the
browser
5 Channels stored in the History List
6 Inputs or channels labels
To toggle among the available lists:
1 Open the Channel Browser ™ .
2
Press B or b.
Note:
• The History List opens by default. After selecting
another list, the Channel Browser ™ will open in the last
selected list.
To tune to a channel or input in Browse mode:
1
Highlight an item. The TV tunes to the channel or
input.
2 Press O to close the Channel Browser ™ .
To tune to a channel or input in Select mode:
1 Highlight the item you want to be tuned.
2
Press .
3 Press O to close the Channel Browser ™ .
Adding and clearing channels and inputs in the
History List
Adding channels to the History List:
As a channel or input is tuned, the Channel Browser
™
adds it to the History List and displays it on the right
side of the Channel Browser
™ .
Previously tuned channels and inputs shift to the left.
Press C to surf back through the previously tuned
channels and inputs.
The Channel Browser
™ stores these channels:
•Channels that are tuned using the numeric buttons on
the remote control.
•Channels that are tuned for at least 5 seconds using <
or ,.
To clear channels from the History List:
•Reconfigure the ANT/CABLE input.
•Turn off the TV.
Using Channel Return
You can switch between two channels without entering
a channel number each time. This feature also works for
external inputs.
1
Select the first channel you want to view.
2
Select a second channel using the Channel Number
buttons (and the dash (=) button if needed).
3
Each time you press , the TV switches back and
forth between the last two channels that were
tuned.
Using SurfLock ™
The SurfLock ™ feature temporarily memorizes one
channel to the button, so you can return to it
quickly, but one time only, from any other channel with
. This feature also works for external inputs.
To memorize a channel to the button:
1
Tune the channel you want to program into the
button.
2
Press and hold for about 2 seconds until the
message “Memorized” appears. The channel has
been programmed to the
button.
3 You can then change channels repeatedly, and
when you press
, the memorized channel will
be tuned.
After pressing and then changing channels again,
the memory is cleared and the button functions as
Channel Return.
88
History
Video 3 11 8
VCR DVD
HDMI 1
5
1 2 4 3
6
O K
WX800U_EN.pdf 37 2010/08/11 10:14:51