Toshiba IK-6400A - Manual (Page 3)

1-3
7. NOTES ON USE AND INSTALLATION
Do not aim the camera at the sun
Do not aim the camera at the sun or point it at sun even if you are not
shooting.
Do not shoot intense light
Intense light such as a spotlight may cause a bloom or smear. A vertical
stripe may appear on the screen. However, this not a malfunction.
Treat the camera with care
Do not drop the camera or subject it to strong shock of vibration. Otherwise,
the camera may malfunction.
Never touch internal parts
Do not touch the internal parts of the camera other than the parts specified.
Otherwise, the camera may malfunction.
Do not splash water on the camera
Install the camera where the camera can be kept dry. If the camera gets
wet, turn off the power and contact your dealer.
Install the camera
Where no video noise appears
If cables are wired near electric lighting wires or a TV set, noise may appear
in images. In this event, relocate cables or reinstall equipment.
Check the ambient temperature and humidity
Avoid using the camera where the temperature is hotter or colder than
specified. Otherwise, the quality of images may deterlorate or internal parts
may be affected. Special care is required to use the camera at high
temperature and humidity.
Should you notice any trouble
If any trouble occurs while you are using the camera, turn off the power
and contact your dealer. If you continue to use the camera when there is
something wrong with it, the trouble may much worse and an unpredictable
accident may occur.
6. BACKLIGHT COMPENSATION (BLC)
This function is activated when the BLC switch is set to on.
When the automatic electronic iris and the auto iris lens is used, the exposure
adjustment is automatically performed so that a best picture is obtained at a
monitor zone of about 60% in horizontal and about 60% in vertical direction.
This function is effective when a strong light enters the portion other than this
zone and auto iris lens closes and darkens the area to view.
BLC
ON
OFF
(Monitor screen)
50%
50%
5. AUTOMATIC ELECTRONIC SHUTTER (AES)
Exposure time is controlled automatically within a range of 1/60 sec. to 1/
100000 sec. to obtain an adequate signal when the back panel switch is
turned to AES.
When the back panel switch is turned to VIDEO or DC, the exposure time is
fixed 1/60 sec.
8. IN CASE OF PROBLEMS 9. PART NAMES & FUNCTIONS :
Condition
No image
Unnatural color
Check Point
Are the camera and connected equipment turned on?
Is the iris of the lens adjusted properly?
Are cables connected correctly?
Is the monitor TV adjusted correctly?
Is the lighting too weak?
When external light and internal light are mixed or when the
object includes some chromatic colors are shot, a hue may
partly have a little difference.
Note
116
A
uto-IRIS T
e
rminal
F
ocus r
ing :
Rotate the r
ing to
appropr
iate setting.
Video output ter
minal :
connect to a
TV monitor
, etc.
LEVEL : DC-T
ype AI Lens
adjustment tr
immer
A
C24V/DC12V
po
w
er ter
minal
AES/VIDEO DC select s
witch :
AES :
A
uto electronic shutter function.
VIDEO :
When using AI lens (with amp).
DC :
When using AI lens (without amp).
F
ocus Loc
k Scre
w
V PHASE : Line-Loc
k Phase
adjustment ter
minal
Select s
witch :
Line Loc
k mode ON/OFF
BLC ON/OFF
Dimensions :
mm
Lens : Mount a CS-mount lens
.
Left side
Vie
w
T
op Vie
w
Rear Vie
w
Fr
ont Vie
w
Right Side
Vie
w
50
63