TRENDnet Industrial Single Board Computer HS-6038 - Manual (Page 32)

26
Pin 1
Location
DiskO
nChip
4. The installation is now complete and your module is now ready
for use.
NOTE: If you encounter difficulty installing your DiskOnChip  module,
please consult a qualified technician or engineer to perform the
installation.
3.26.2 Removing DiskOnChip  Modules
When removing a DiskOnChip  module from its socket, please take
note of the following:
1. Loosen the contact of the module from its socket using a
screwdriver.
2. Insert the screwdriver’s flat head into a gap on either end of the
socket. Do not insert the screwdriver head on either side where
the pins are located. Doing so might damage the pins in the
process.
3. Slowly lift the screwdriver handle upwards. This will disengage
the module from its socket.
NOTE: If you encounter difficulty removing your DiskOnChip  module,
please consult a qualified technician or engineer to remove it for
you.