Toro Sprinkler Timer with Computer Programming Option ECXTRA - Manual (Page 30)

PGM A
1 2 3 4 5 6
3 5
3 5
9
4
3
5
2 1
4 2
5
Turn the control dial to the
set zone times
position.
Check the programs
switch setting. If necessary,
reposition the switch to select the desired program.
Zone number 1 will be flashing and its current run
time or OFF will be shown. To select a different zone
number, press the +/
on
or –/
off
button until the
desired zone number is flashing.
Press the next
button. The run time (or OFF) will
begin flashing.
To set the run time, press the +/ on
or –/
off
button
until the desired run time is shown.
Note: To remove the run time, select OFF by press-
ing the +/
on
and –/
off
buttons at the same time.
Press the next
button. The next zone number will
begin flashing.
7. Repeat steps and as needed to set, change, or
remove the run time for the remaining zones.
8. To set the zone run time for another program, repeat
all of the steps starting at step .
Return the control dial to the run
position.
Note: Basic programming is now complete.
If the ECXTRA is controlling a water supply pump,
continue at “Pump Control” on page 29 for important
operating information.
Setting Zone Run Times

3
9
3 5
4
3 5
5 4 2
1
6