Troy-Bilt 753B - Manual (Page 5)

3
10. Mower blades are sharp and can
cut. Wrap the blade or wear gloves,
and use extra caution when servic-
ing them.
11. Do not change the engine governor
setting or overspeed the engine.
12. Do not touch engine parts which
may be hot from operation. Allow
parts to cool completely before in-
specting, cleaning or repairing the
mower.
13. To access the underside of the
mower, tip the mower rearward. Do
not tip the mower forward or on ei-
ther of its sides, unless specifically
advised to do so in this manual.
14. Maintain or replace safety and in-
structional decals. Refer to the sep-
arate Parts Catalog for replacement
decal information.
15. For units equipped with electric
start:
a) Batteries produce explosive
gases. Keep sparks, flame,
cigarettes, etc., away. Ventilate
the area when charging the bat-
tery. Do not charge the battery in
an airtight space.
b) Do not use a battery charger
other than the one provided with
the mower.
c) The battery contains toxic mate-
rials. Do not damage the battery
case. If the case is broken or
damaged, avoid contact with the
battery contents.
d) Properly dispose of a damaged
or worn out battery. Check with
local authorities for proper dis-
posal methods.
e) Do not short circuit the battery.
Severe burns and fire can result.
Section 1: Safety
SAFETY DECALS
Make certain all safety decals on this equipment are kept clean and in good condition. The decals are shown (at reduced sizes)
below. If you need a replacement decal, please refer to the Parts Catalog that accompanied this Manual.
WARNING
PINCH POINTS
Do not operate with-
out all belt guards
in place.
Beneath belt/pulley cover
On Control Panel (for electric start model)
On Control Panel (for recoil start model)
On left side of mower deck
On discharge chute