TC electronic SDN BHD PowerCore - Manual (Page 7)

SOFTWARE INSTALLATION GUIDE WINDOWS
We recommend installing the software before connecting/installing the hardware.
• Close ALL running applications.
• Insert the PowerCore CD in your computers CD-ROM drive.
• The installer should start automatically. If it does not, then navigate to the CD
ROM drive and doubleclick the: SETUP.exe
• The following screen appears:
• Read, act and click NEXT.
• The License agreement screen appears.
• Read and check “I accept the license agreement”, if you agree; click NEXT.
• Read the POWERCORE SOFTWARE INSTALLATION Read ME & Limited Hardware
Warranty and press NEXT.
• The installer now suggests a default location for installing the PowerCore package
• The installer is now ready to install the software.
Click NEXT to proceed or press BACK to re-enter the installation information.
To exit the installation press CANCEL.
• When the installation is complete, connect/install your PowerCore hardware.
EE
NN
GG
LL
II
SS
HH
10 / POWERCORE POWERCORE / 11
EE
NN
GG
LL
II
SS
HH
For detailed information on how to connect/install your PowerCore hardware please
refer to page 14-15.
• After connecting/installing the PowerCore hardware the computer may indicate
that it has “found new hardware” and the following “Welcome to the Found New
Hardware Wizard” may appear.
• Select “No, not this time” and press NEXT.
• Now select “Install the software automatically” and press NEXT.
• After completing the software installation click FINISH and Windows will indicate
that the installation is complete:
Congratulations - the installation is now complete.