Tripp Lite B095-004-1E - Manual (Page 4)

4
Tripp Lite follows a policy of continuous improvement. Product specifications are subject to change without notice.
201203076 • 932978-EN
Advanced
• Check “Receive DSR/DCD/CTS changes” if the flow control signal status from the
physical serial port on Console Server is to be reflected back to the Windows COM
port driver (as some serial communications applications prefer to run without any
hardware flow control, i.e., in “two wire” mode).
• The “Propagate local port changes” allows complete serial device control by the
Windows application so it operates exactly like a directly connected serial COM port.
It provides a complete COM port interface between the attached serial device and
the network, providing hardware and software flow control. So the baud rate, etc., of
the remote serial port is controlled by the settings for that COM port on a Windows
computer. If not selected, then the port serial configuration parameters are set on the
console server.
o With the “Emulate Baud Rate” selected, VirtualPort will only send data out at the
baud rate configured by the local application using the COM port.
VirtualPort for Windows
continued
1111 W. 35th Street, Chicago, IL 60609 USA
www.tripplite.com/support
201203076 93-2978.indd 4 3/13/2012 3:08:58 PM