Transition Networks E-PSW-TX-02 - Manual (Page 16)

2. SITE CONSIDERATIONS
The site for the Transition Networks’ pocket switch must provide:
• AC power outlet for each Transition Networks’ pocket switch
• Adequate ventilation
• Standard environmental conditions
• Isolation from electrical noise, including radio transmitters and
broadband amplifiers, motors, high power electrical lines, or
fluorescent light fixtures.
Additionally:
• The twisted pair cables should not run in the same conduit with
power line cables.
• Phone lines should be separated from data cables.
• Flat or “silver satin” wires should not be used.
And:
• The entire installation should comply with the IEEE Ethernet
802.3 and the 802.3u specifications.
3. INSTALLATION
To install the Transition Networks’ pocket switch:
• Unpack Transition Networks’ pocket switch
• Install Transition Networks’ pocket switch on stable, flat
surface
• Set DIP switch
• Install network cable
•
Power Transition Networks’ pocket switch.
Direction is provided in the pages that follow.
Unpacking the Transition Networks’ Pocket Switch
The Transition Networks’ pocket switch packing contents should
include the following:
Item Part Number
Transition Networks’ E-PSW-TX-02
Pocket Switch OR
E-PSW-FX-02
Power Supply Adapter 3340, 3507, 3342, 3340, 3346, 3511,
OR 3537
/power cord: 3522 .
(depending upon power configuration
in country where installed)
User’s Guide 33015
Installing on Flat, Stable Surface
The Transition Networks’ pocket switch was designed and built to be
installed on a table or shelf.
Ensure that the installation location is:
• stable
• well- ventilated
• near a standard AC electrical outlet.
Transition Networks’ Pocket Switch 14 13