Document Outline

• SAFETY MESSAGES
• TABLE OF CONTENTS
• FIGURES
• TABLES
• 0 INTRODUCTION
  • 1 Preface
  • 1.2 WARRANTY POLICY
    • ADVANCED POLLUTION INSTRUMENTATION DIVISION
  • 1.3 Principle of Operation
  • 1.4 Specifications
• 2.0 Installation
  • 2.1 Mechanical Installation
  • 2.2 Pneumatic Connections
  • 2.3AC Power Connection
  • Electrical I/O Connections
    • 2.4.1 Analog Output
    • 2.4.2 Digital Status Outputs
    • 2.4.3 Control Inputs
    • 2.4.4 RS232/RS485 Serial Communications Port
• 3.0 Startup
• 4.0 Operation
  • 4.1 Front Panel Display
    • 4.1.1 O3 readout
    • 4.1.2 Pressure Display
    • 4.1.3 Zero Calibration
    • 4.1.4 Status LED’s
  • 4.2 Auto-Zero Operation
    • 4.2.1 Auto-Zero Installation
    • 4.2.2 Auto-Zero Function
    • 4.2.3 Auto Zero Error
• 5.0 Serial Communications
  • 5.1 Serial Port Configuration
  • 5.2 Command Syntax
  • 5.3 Command Summary
  • 5.4 Command Reference
    • 5.4.1 CAUTO
      • Syntax
        • Description
          • Data Parameters Sent
          • Response
    • 5.4.2 CZERO
      • Syntax
        • Description
          • Data Parameters Sent
          • Response
    • 5.4.3 DACSTEP
      • Syntax
        • Description
          • Data Parameters Sent
          • Response
          • Example
          • Notes
    • 5.4.4 O3
      • Syntax
        • Description
          • Data Parameters Sent
          • Response
          • Example
          • Notes
    • 5.4.5 SETADDR
      • Syntax
        • Description
          • Data Parameters Sent
          • Response
          • Example
          • Notes
    • 5.4.6 TDUMP
      • Syntax
        • Description
          • Data Parameters Sent
          • Response
          • Example
          • Notes
    • 5.4.7 TLIST
      • Syntax
        • Description
          • Data Parameters Sent
          • Response
          • Example
          • Notes
    • 5.4.8 VGET
      • Syntax
        • Description
          • Data Parameters Sent
          • Response
          • Example
    • 5.4.9 VLIST
      • Syntax
        • Description
          • Data Parameters Sent
          • Response
          • Example
          • Notes
    • 5.4.10 VSET
      • Syntax
        • Description
          • Data Parameters Sent
          • Response
          • Example
• 6.0 Maintenance
  • 6.1 Replacing the gas filter element
  • 6.2 Cleaning Exterior Surfaces of the M460H
  • 6.3 Degree of Protection
• 7.0 Sensor and System Troubleshooting
  • 7.1 Status Output Summary
  • 7.2 Sensor OK
  • 7.3 Invalid Reading
  • 7.4 Lamp Low
  • 7.5 Cell Dirty
  • 7.6 Status Output Summary Table
• Appendix A – Serial Port Configuration
• Appendix B – Pneumatic Diagram