Topcom ULTRASONIC 1801 - Manual (Page 4)

4
TOPCOM Ultrasonic Humidifier 1801
2 Technical specifications
– Moisture capacity: 300ml/h
– Water tank volume:6L
– Rated voltage: 230 V AC
– Rated frequency: 50Hz
– Rated power:50W
– Prevent electric-shock protection: II sort
3 Description
a. Handlebar
b. Water Inlet Cap
c. Water level low detection
d. Power cord
e. Key pad
f. LCD display
g. Water flume
h. Water tank
i. Fume dispenser
4 Installation
• Put the humidifier on a flat surface in the room for half an hour. It is important that it reaches the
ambient temperature.
• We recommend using the humidifier at a temperature between 5 and 40°C and a relative humidity
of less than 50%.
• Remove the water tank (h) from the humidifier.
• Turn the water tank up side down.
• Unscrew the cap (b) by turning it counter clockwise.
• Fill the water tank with clear water (maximum 40°C).
• Close the cover by turning clockwise.
• Verify the cleanliness and watertightness and then gently put the & water tank back on the base.
• Position the spray mouth (i) in the desired direction.
• Plug the power cord (d) in the main power wall connector with dry hands.
Do not remove the water tank when the humidifier is connected to the main power.
When you remove the water tank after usage, there will still be water in the water flume.
Remove the water from the tank and flume when it is not used for a long period.
Clean the water box, spray mounth and water flume if the humidifier is not used for a long period.
Do not position the humidifier near heat sources or direct sunlight.
Do not aim the fume dispenser to furniture, electronic equipment or baby beds.
a
b
c
d
e
f
g
h
i