Texas Instruments TPA2008D2 - Manual (Page 13)

2-1 Operation
Operation
The steps in this chapter can be followed to quickly prepare the TPA2008D2
stereo filter-free class-D audio amplifier EVM for use. Using the TPA2008D2
with the TI plug-n-play audio amplifier evaluation platform is a quick and easy
way to connect power, signal and control inputs, and signal outputs to the EVM
using standard connectors. However, the audio amplifier evaluation module
can be used stand-alone by making connections directly to the module pins,
and can be wired directly into existing circuits or equipment.
The platform switch and jumper settings shown in Table 2–1 are typical for the
TPA2008D2 EVM and causes the TPA2008D2 to shut down when a plug is in-
serted into platform headphone jack J10.
Table 2–1. Typical TI Plug-N-Play Platform Jumper and Switch Settings for the
TPA2008D2
EVM JP4 JP5 JP6 JP7 JP8 S2 S3
P-N-P Platform X ON Mute X Lo Note 2 U5
Notes: 1) ON = Jumper installed, OFF = Jumper NOT Installed, X = Don’t care
2) Set S2 to ON when signal conditioning board is installed in U1; set S2
to OFF when no signal conditioning board is installed.
Topic Page
2.1 Precautions 2–2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2.2 Quick Start List for Platform 2–3 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2.3 Quick Start List for Stand-Alone 2–4 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2.4 Power Requirements 2–6 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Chapter 2