Toshiba TDP-FF1A - Manual (Page 26)

26
Basic operations
1 Turn on the power.
Turn on the power by following the instructions in “ Turning the power on (I)” .
2 Activate the connected device.
Turn on and start the connected device such as a computer.
3 Press the INPUT button.
See remote control section on .
4 Adjust the focus.
Use the focus ring to adjust the focus.
5 Adjust the vertical projection angle.
Rotate the foot adjuster to adjust the vertical position of the projection image. See foot
adjuster on .
6 Adjust the volume.
Adjust the volume from the control panel or remote control.
Notes
• The DMD TM is made using extremely advanced technology, but there may be black spots
(pixels that do not light) or bright spots (pixels that are constantly lit) on the panel. Please
note that these are not malfunctions.
• Although this projector supports a wide range of RGB signals , any signal formats
not matched to native resolution of this projector (SVGA) will be expanded or shrunk,
which will affect image quality slightly. To view high-quality images, setting the computer’s
external output to SVGA is recommended.
• With some models of computer having LCD displays or the like, displaying images
simultaneously on the projector and the monitor’s display may prevent the images from
displaying properly. If this happens, turn off the computer’s LCD display. For information
on how to turn off the LCD display, see the owner’s manual of your computer.
• If a signal not supported by the projector is input, the “Unsupport signal” will appear.
• If an unavailable operation button is pressed, the
icon will appear.
• The factory setting for the OSD language is “English”, other languages can be selected in
the Default setting menu.