Top Innovations SF-220 - Manual (Page 9)

9
Water Filling Instructions
1. Place the unit on a level surface.
2. Unplug the Power Cord.
If the steam cleaner is still hot from a previous use, complete steps 3-5 below.
Otherwise proceed to step 6.
3. Press the Steam Button continuously until all steam is removed from the unit.
4. Continue to press the Steam Button while cautiously unscrewing the Safety
Cap.
Caution: Always press the Steam Button while unscrewing the Safety Cap.
This ensures any steam still inside the unit will be safely vented out of the
nozzle.
5. Let the unit cool for at least 5 minutes.
Warning: Always allow the unit to cool before adding water. Cold water
added to a hot boiler can cause hot water and steam to shoot out of the fill
hole.
6. Remove the Safety Cap and empty any water that might remain from a previ-
ous use.
Caution: Emptying the unit before filling it ensures that the proper amount
of water is added. Too much water can cause water droplets in the steam and
could damage the unit.
7. Fill the Measuring Cup to the maximum fill line with water (6 oz or 180 ml).
Note: To prolong the lifetime of your steam cleaner, we recommend using
Distilled or De-mineralized water.
8. Carefully line up the spout on the Measuring Cup with the water fill hole and
slowly pour the contents down the fill hole.
Warning: Extreme care should be taken when pouring water into the boiler.
Do not look directly down the fill hole when filling the water .
9. Replace the Safety Cap (Do not over tighten the cap).